Cutting path commonly used in machining parts on CNC lathes

July 10, 2023

The commonly used tool path for machining parts on CNC lathes:

(1) analysis of the car's arc path

When the actual car arc, it needs multi-knife processing, first remove most of the excess, and finally the car needs the arc. The following describes the processing route commonly used for car arcs.

Figure 1 shows the course of the arc of a car.

figure 1

Figure 2 (a) is a concentric circular arc path for the car arc.

figure 2

Figure 3 shows the car cone cutting course of the arc

That is, a car first cone, and then car arc.

image 3

(2) analysis of the path of the car cone

Figure 4

(3) Analysis of axial feed distance when threading

Figure 5

(4) analysis of cutting path

In the case of a rectangular groove with low turning accuracy and narrow width, a slot cutter with a blade width equal to the slot width can be used to feed the car at a time using the straight-in method. Grooves with higher accuracy are generally used as secondary feeds, ie, when feeding the trough for the first time, the remaining amount of fine cars is left on both sides of the trough, and the second pass is trimmed with a constant width knife.

The wide groove of the car can be cut by multiple straight-through methods, leaving a fine machining allowance in the groove wall and the bottom surface, and the last knife to the size. As shown in Figure 6.

Figure 6

The above is the Cutting path commonly used in machining parts on CNC lathes we have listed for you. You can submit the following form to obtain more industry information we provide for you.

You can visit our website or contact us, and we will provide the latest consultation and solutions

Share to:

Send Inquiry

Previou:Introduction to the Drive and Control System of CNC Machine Tools

Next:Fault Analysis and Elimination of Reference Point Return of CNC Machine Tools